CNC busbar management content and method of hydraulic ironworker mechanical: 

1. Operators must be familiar with the equipment of the main structure, properties and processing parameters using range, can use the machine. Before and after the machine runs are strictly prohibited to any parts of the body into the mold, so as to avoid task.

2. The operator to start the equipment before, carefully check, complete their own labor protection supplies wear, electrical, mechanical, hydraulic, mold, find out problems in time, according to provisions of lubrication and gas rear can start to use.

3. In machine open, open the electrical cabinet total power supply, closed control switch, turning the scram button, pneumatic, hydraulic station, determine the machine within the scope of work, has nothing to do with the work of personnel, goods, after boot.

4. Each class before work requirements, boot empty running 15 minutes (the oil pump of the hydraulic pressure station), boot self-checking, machine X, Y, Z axis back to the origin, behind the block corresponding to the sensor's zero point.

5. According to the thickness of the hydraulic ironworker safety bus, shape, aperture size to choose the appropriate parameters such as mould, and properly installed and tightened. In order to ensure the accuracy of punching and shearing, bus must level off, and kept in the center of pressure of the machine tool, should not be unilateral load, special bus must add bracket, balance and then carry on the processing.

6. Operation of the equipment, it is forbidden to anyone or anything behind collision hydraulic ironworker safety test machine platform, frame and sensor components, to ensure that the personal and the safe operation of the equipment.

7. Used to observe the equipment running status, if discover the abnormal phenomenon, immediately stop, disconnect the power equipment management department and report. No one can be without permission from the relevant departments of the disassembling repair without authorization.

8. After the hydraulic ironworker tools downtime must be cut off power supply, the operation button and handle all in the non-work position, wipe the device requirements: paint ecru, iron see light, hydraulic ironworker review machine mesa and the mould must be refueling rust, clean up, keep working environment clean and tidy and clean.

9. After the hydraulic ironworker work, clean equipment, clean sanitation and maintain clean sanitation. After cleaning the waste, should focus company relevant departments of the unified process. Avoid to cause secondary pollution.

We are professional manufacturer of hydraulic ironworker machine. Welcome to our factory. If you are interested in our machines, just send us an email. (anson@sinokd.com; john@sinokd.com)